How To Install Pergo Xp Stair Nose

If so, you may not want to install laminate on your stairs. No doubt about it looks nice as can be. But is very slippery, to say the least. OK, the for the big bucks. 2019 hacking tools. The stair nosing that I used in this video was not cheap at all. When you go to buy the laminate floor of your choice ask them if they have “matching” stair nosing. A stair nose is a special piece of trim that is installed over the edge of each stairway to eliminate sharp corners. The Pergo Company makes a line of stair noses, which you can install on your staircase with finishing screws. Instructions to installing pergo stair nose, starting with measure staircase. You will attach stair edge to the tape measure.

Related Articles

• 1 Stain a Stair Nose
• 2 Apply False Stair Treads
• 3 Trim Out a Closet Door
• 4 Hide Gaps in a Staircase

Stair nose molding is used in conjunction with a hardwood floor installation to finish off the step or stairwell where the hardwood floor stops. Stair nose molding is about 4 to 5 inches wide, with a rounded bullnose edge that extends down to cover the edge of the step and is typically placed on the step before the hardwood. If you plan to install hardwood flooring anywhere in your home where there's a shelf or a step, you can use stair nose molding to achieve a finished look. Proper stair nose installation can add value to any home.

1

Measure across the front of the step. Place the molding flat on a miter saw, face up and cut it to match the measurement.

2

Run a bead of construction adhesive across the top front of the step, 1 inch from the edge. Place the stair nose molding in place. Using a drill with a 1/16-inch drill bit, drill holes down through the top of the stair nose 2 inches from its edge, spaced 6 inches apart.

3

Hammer 2-inch screw nails into the holes. Stop when the nail is within 1/4-inch of the surface of the molding and use a nail set to finish driving the nail 1/8-inch below the surface of the molding.

4

Cut miters on either end of the molding with a miter saw for stairwells, landings or anywhere steps are made with two pieces at an angle. Fit the miters together. Drill and nail the pieces together as you would any straight piece. Use a matching color crayon to fill the nail holes. Download xforce keygen autocad 2013 for mac free.

5

Place the first piece of hardwood flooring butted tight against the flat part of the bull nose and continue installing the remainder of the flooring.

Things You Will Need

• Miter saw
• Construction adhesive
• Cordless screw gun
• 1/16-inch drill bit
• 2-inch screw nails (nails with threads)
• Hammer
• Nail set
• Putty crayon

Tip

• You can trim the back of the bull nose off if you need to with a table saw if the hardwood floor has already been installed and you need to cut the bull nose to fit the stair.

Warning

• Always wear safety glasses when working with wood.

About the Author

Specializing in hardwood furniture, trim carpentry, cabinets, home improvement and architectural millwork, Wade Shaddy has worked in homebuilding since 1972. Shaddy has also worked as a newspaper reporter and writer, and as a contributing writer for Bicycling Magazine. Shaddy began publishing in various magazines in 1992, and published a novel, “Dark Canyon,” in 2008.